QTECH QSW-2800 Инструкция по настройке - Manual (Page 320)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
306
no am enable
2. Enable AM function on an interface
Command Explanation
Port Mode
am port
no am port
Enable/disable AM function on the port. When the
AM function is enabled on the port, no IP or ARP
message will be forwarded by default.
3. Configure the forwarding IP
Command Explanation
Port Mode
am ip-pool
no am ip-pool
Configure the forwarding IP of the port.
4. Configure the forwarding MAC-IP
Command Explanation
Port Mode
am mac-ip-pool
address>
no am mac-ip-pool
Configure the forwarding MAC-IP of the port.
5. Delete all of the configured IP or MAC-IP or both
Command Explanation
Global Mode
no am all [ip-pool|mac-ip-pool]
Delete MAC-IP address pool or IP address pool
or both pools configured by all users.
6. Display relative configuration information of AM
Command Explanation
Global Configuration Mode
show am [interface ]
Display the AM configuration information of one
port or all ports.