QTECH QSW-2800 Инструкция по настройке - Manual (Page 39)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
25
[access {|}] [ipv6-access
{|}]
no snmp-server user [access
{|}] [ipv6-access {
std>|}]
for SNMP v3.
6. Configure group
Command Explanation
Global Mode
snmp-server group
{noauthnopriv|authnopriv|authpriv} [[read
string>] [write ] [notify
string>]] [access {|}] [ipv6-
access {|}]
no snmp-server group
{noauthnopriv|authnopriv|authpriv} [access
{|}] [ipv6-access {
std>|}]
Set the group information on the
switch. This command is used to
configure VACM for SNMP v3.
7. Configure view
Command Explanation
Global Mode
snmp-server view
{include|exclude}
no snmp-server view []
Configure view on the switch. This
command is used for SNMP v3.
8. Configuring TRAP
Command Explanation
Global Mode
snmp-server enable traps
no snmp-server enable traps
Enable the switch to send Trap
message. This command is used for
SNMP v1/v2/v3.
snmp-server host { |
ipv6-address> } {v1 | v2c | {v3 {noauthnopriv |
authnopriv | authpriv}}}
no snmp-server host { |
} {v1 | v2c | {v3
{noauthnopriv | authnopriv | authpriv}}}
string>
Set the host IPv4/IPv6 address
which is used to receive SNMP Trap
information. For SNMP v1/v2, this
command also configures Trap
community string; for SNMP v3, this
command also configures Trap user
name and securi
ty level. The “no”