QTECH QSW-2800 Инструкция по настройке - Manual (Page 410)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
396
5. Display executed-commands state
Display and clear log buffer zone
Command Description
Admin Mode
show logging buffered [ level {critical | warnings} |
range <begin-index> <end-index>]
Show detailed log information in the
log buffer channel.
clear logging sdram Clear log buffer zone information.
Configure the log host output channel
Command Description
Global Mode
logging { | } [ facility
number> ] [level ]
no logging {> | <ipv6-addr>} [ facility
<local-number>]
Enable the output channel of the log
host. The “no” form of this command
will disable the output at the output
channel of the log host.
logging loghost sequence-number
no logging loghost sequence-number
Add the loghost sequence-number
for the log, the no command does not
include the loghost sequence-
number.
Enable/disable the log executed-commands
Display the log source
Command Description
Global mode
logging executed-commands {enable | disable}
Enable or disable the logging
executed-commands
Command Description
Admin and configuration mode
show logging source mstp
Show the log information source of
MSTP module.