QTECH QSW-2800 Инструкция по настройке - Manual (Page 47)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
33
switch, the running configuration file stores in the RAM. In the current version, the running
configuration sequence running-config can be saved from the RAM to FLASH by write
command or copy running-config startup-config command, so that the running configuration
sequence becomes the start up configuration file, which is called configuration save. To
prevent illicit file upload and easier configuration, switch mandates the name of running
configuration file to be running-config.
Factory configuration file: The configuration file shipped with switch in the name of factory-
config. Run set default and write, and restart the switch, factory configuration file will be loaded
to overwrite current start up configuration file.
2.5.3.2 FTP/TFTP Configuration
The configurations of switch as FTP and TFTP clients are almost the same, so the
configuration procedures for FTP and TFTP are described together in this manual.
2.5.3.2.1 FTP/TFTP Configuration Task List
1. FTP/TFTP client configuration
Upload/download the configuration file or system file.
For FTP client, server file list can be checked.
2. FTP server configuration
Start FTP server
Configure FTP login username and password
Modify FTP server connection idle time
Shut down FTP server
3. TFTP server configuration
Start TFTP server
Configure TFTP server connection idle time
Configure retransmission times before timeout for packets without acknowledgement
Shut down TFTP server
1. FTP/TFTP client configuration
(1) FTP/TFTP client upload/download file
Command Explanation
Admin Mode
copy
url> [ascii | binary]
FTP/TFTP client upload/download file.
(2) For FTP client, server file list can be checked.
Admin Mode