S&B Filters Cold Air Intake Kit - Cotton Filter 75-5039 - Manual (Page 3)

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbfilters.com
Installation Instructions (continued)
Helpful Hint
Some vehicles experience a high pitch whistle at
2000-2200rpm. This noise has been associated
with increased air flow but is also common on
stock vehicles. You can remove the throttle body
and replace the gasket/ screen with Toyota part
#: 22271-50050 without this screen. Doing this
will also decrease restriction.
3
P/N: 75-5039 / 75-5039D
Related Items
Available at www.sbfilters.com
• Precision II Filter Cleaning & Oiling Kit
(S&B P/N: 88-0008)
• Replacement Air Filter (Oiled)
(S&B P/N: KF-1056)
• Replacement Air Filter (Dry)
(S&B P/N: KF-1056D)
• Air Filter Wrap
(S&B P/N: WF-1034)
Air Box End Cap Testing
Stock air boxes are a significant contributor to poor air flow which is why S&B designs custom air boxes with secondary and/or enlarged openings. With
that said, S&B recognizes the benefits of cooler air, so we have included a plug to seal off the opening if so desired. For optimal performance, we
recommend that the intake be used without the end cap except in conditions of extreme heat. Without the plug installed on the box, there is an additional
improvement in airflow.
Visit the product page for this intake at www.sbfilters.com to see the actual test results outlined in detail.
EMISSIONS LEGALITY
NOT LEGAL FOR USE IN CALIFORNIA OR OTHER STATES ADOPTING
CALIFORNIA EMISSIONS STANDARDS
24.
Reconnect the battery. Reinstall the
engine cover. Inspect your installation, make
sure the kit is properly positioned and all
fasteners are secure. The installation is now
complete.
Removing the Filter for Maintenance:
1. Remove the clear cover and air box plug (if installed).
2. Loosen the hose clamp and carefully pull the filter off the tube and turn it clockwise
3. Carefully remove the filter through the top of the air box.
Testing and Maintenance
• Engage parking brake and start your engine.
Listen for abnormal noises. If an air leak is
detected, re-inspect hoses and connections as
they may need to be repositioned and tightened.
• S&B Filters recommends that you keep your OE
intake system in the event it is required in the
future.
• In order to maintain your warranty, all connections
and components must be checked periodically for
alignment and for proper tension on all
connections every 6-12 months. Failure to do so
may void your warranty.
• Use only S&B FILTERS cleaning and oil products
to service your filter. Using any other brand oil
and or cleaners on your S&B air filter will void
your warranty.
SEE EXPLODED VIEW ON PAGE 4
23.
Install the Clear Lid (E) using the supplied
1/4”x1-1/4” S.S. Screws (V) and the 1/4”x5/8”
S.S Screws (U) and Rubber Washers (T) . This
will secure the Filter Adapter to the Air Box as
well.
(Do not over tighten!)
21.
Push the fuel pressure regulator vent
tube over the hose barb attached to the intake
tube.
22.
Reconnect the MAF Sensor wiring
harness to the MAF sensor.