S&B Filters Cold Air Intake Kit - Cotton Filter 75-5039 User Manual
Installation instructions, Vehicle application, Tools required

1.
With the ignition switched off and the
parking brake set, disconnect the negative
battery cable on the driver’s side. Remove the
engine cover by lifting it from the front and un-
hook it from the rear tabs.
Installation Instructions
Vehicle Application
Year: 2007-14
Make: Toyota
Model: Tundra / Sequoia
Engine: 5.7L V8
15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -
5.
Loosen the two bolts secure the OE air
box to the inner fender. Then remove the air
box from the truck by lifting up and sliding the
inlet tube out of the fender hole.
6.
Install the Fender Seal
(D)
onto the inlet
of the Air Box
(B)
.
2.
Disconnect the MAF Sensor wiring
harness from the sensor. Disconnect the
harness from the air box lid.
8.
Install the two supplied Grommets
(K)
into
the bottom of the Air Box
(B)
.
P/N: 75-5039 / 75-5039D
SEE EXPLODED VIEW ON PAGE 4
1
Tools Required
• Ratchet and extensions
• 10mm, 13mm Wrench & Socket
• 7/16” Wrench and Socket
• 5/16” Nut Driver or Flat Blade Screwdriver
• Phillips Screwdriver
Notes
Kit may not fit with the following
Aftermarket Parts installed:
• Body Lift or Lowering Kit
• Custom Hood
• Throttle body upgrades
S&B Filter Maintenance
Cleanable
(KF-1056)
. If the enclosed filter is Red, it came pre-oiled
from the factory. Please visit
amount required after cleaning.
Disposable
(KF-1056D)
. If the enclosed filter is White, it is a
disposable filter and should be discarded once it reaches capacity.
This filter
(does not require oil)
. For more info on S&Bʼs disposable
.
Before You Start
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.
3.
Disconnect the crank case vent hose and
the fuel pressure regulator vent hose from the
OE intake tube.
4.
Loosen the hose clamp at the throttle
body and air box locations. Then remove the
OE intake tube from the truck.
7.
For those concerned about minimal engine heat and noise; insert the Air Inlet Plug
(C)
into the
side of the Air Box
(B)
. For those seeking additional air flow, set the Air Inlet Plug aside. Plug will
snap into place and can be removed by taking the lid off and pushing from inside the air box.
(See
page 3 for more info and test results)