R&M Materials Handling VARIABLE SPEED CONTROLS ControlMaster Plus Service Manual - Manual (Page 26)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
26/83 R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
STOP
Stop button
Stops the motor if keypad is the active control place
WARNING! Changing parameter settings during running may cause a hazardous
situation. Parameter settings must not be changed during running.
WARNING! Driving via display may cause a hazardous situation. Panel control must
not be used.
2.1.1 Navigation on the control keypad
READY STOP
G2.
Parameters
G1 G3
READY STOP
G4.
Monitoring
G1 V19
READY STOP
G5.
Panel Control
B1 R2
READY STOP
M6.
System Menu
S1 S9
READY STOP
M7.
Active Faults
F0
READY STOP
M8.
Fault History
H1 Hxx
READY STOP
G2.2.
Motor Parameters
P1 P20
READY STOP
P2.2.1.
Motor Nom Volt
400 V
READY STOP
V4.19.
Output Frequency
0.00 Hz
READY STOP
B5.1.
Panel Control
Off
READY STOP
S6.1.
Application
Crane
READY STOP
H8.1.
57 Thermistor
F T1 T13
READY STOP
Operation days
0
I/O term I/O term I/O term
I/O term
I/O term I/O term
I/O term I/O term
I/O term I/O term
I/O term I/O term I/O term
T8.1.1.
2.1.2 Value line editing
enter
Mode
change Accept
value Edit
value READY STOP
P2.2.1.
Motor Nom Volt
400 V
I/O term
m
WARNING! Changing parameter settings during running may cause a hazardous
situation. Parameter settings must not be changed during running.