PowerWalker VFI 6000T LCD User Manual
Page 23
20
Note
：
：
：
：
●
: Lightened constantly
: #1-#4 Lightened circularly
: Flashing
↑
: Depended on the fault/warning status or other status
Table 5-3 Alarm definition
UPS condition
Buzzer status
Fault active
Continuous
Warning active
Beep every second
Battery output
Beep every 4 seconds, if battery low, buzzer Beep
every second
Bypass output
Beep every 2 minutes
Overload
Beep twice every second
The UPS provides useful information about UPS itself, load status,
events, measurements, identification, and settings through the front
panel display.
During powering on, the LCD would display the Welcome logo for
several seconds and then enter to the default page which shows the
UPS status summary.
The display automatically returns to the default UPS status
summary screen when no button has been pressed for 15 minutes.
On the UPS status summary screen it provides the following
information:
Status summary, including mode and load
Alarm status, if any are present
Notes: alarm including fault and warning information
Battery and charger status, including battery voltage, charge
level and charger status
Running information including parallel UPS and running time