B&B Electronics EIR608-4SFP - Manual - Manual (Page 40)

32
Manual Documentation Number: EIR608-xSFP_4812m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
command to set the
path cost for Spanning
Tree
Protocol (STP)
calculations. In the
event of a loop,
spanning tree
considers the path
cost when selecting
an interface to place
into the forwarding
state.
stp-path-priority
[Port Priority]
I Use the spanning-tree
port-priority interface
configuration
command to configure
a port priority that
is used when two
switches tie for
position as the root
switch.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-path-priority
128
stp-admin-p2p
[Auto|True|False]
I Admin P2P of STP
priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-p2p
Auto
stp-admin-edge
[True|False]
I Admin Edge of STP
priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-edge
True
stp-admin-non-stp
[True|False]
I Admin NonSTP of STP
priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-non-s
tp False
show spanning-tree E Displays a summary of switch>show spanning-tree