B&B Electronics VESP211 Series - Manual - Manual (Page 27)

Section 4 - Configuring the Serial Server Vlinx VESR4x4 Serial Server
Page 27 of 66 Manual Documentation Number: VESP211-5011m
www.bb-elec.com/
www.bb-europe.com/
Figure 22. Network Configuration Page
Setting up Dynamic IP Addressing
1. Select the
I want to use DHCP to setup the network
check box.
Setting up Static IP Addressing
1. Ensure the I want to use DHCP to setup the network box is un-checked.
Figure 23. IP Address Settings
2. Type the IP Address , Subnet Mask and Default Gateway addresses in the
appropriate boxes.
Setting up Serial Ports
On the Serial Port Configuration page you can configure the communications
parameters of the current serial port. Parameters include port mode, baud
rate, data bits, parity, stop bits and type of flow control.