B&B Electronics 856-14869--93 - Manual - Manual (Page 51)

48
• To restore the unit to factory default settings, use the cleandb function via the
serial port (refer to the Device-Specific Options from the Command Line section
for more information). This is especially helpful if the module may have been
configured improperly. If restarting to factory defaults is necessary, IMC
Networks recommends using this function on both units in Host/Remote
applications, then reconfiguring all settings.
• Ensure READ/WRITE Community Strings for iMcV-Giga-FiberLinX-II and iView²
are the same.
• Ensure none of the twisted-pair ports on the iMcV-Giga-FiberLinX-II are
connected to the twisted-pair port on the iMediaCenter chassis or the
management module in an iMediaChassis series chassis.