B&B Electronics 856-14869--93 - Manual - Manual (Page 13)

10
queried by SNMP. As a Remote unit, the iMcV-Giga-FiberLinX-II will respond to
requests for management information from an attached Host unit.
The iMcV-Giga-FiberLinX-II default configuration is as a Standalone unit (DIP
Switches 7 and 8 = OFF).
Management
Although the iMcV-Giga-FiberLinX-II provides a twisted pair port solely for
management (EXT MGMT), the iMcV-Giga-FiberLinX-II can be configured to accept
IP-based management traffic from any of its three ports. Enable management on
more than one port, or disable management on all of the ports, as desired. These
switches limit only IP-based management. Host-to- Remote management is IP-less
and is never blocked from the fiber port. Serial port management of the unit is
always available on the EXT MGMT port regardless of the DIP Switch settings.
In addition to defining which ports are used to manage the iMcV-Giga-FiberLinX-II
units, the management DIP Switch settings also define what ports the flow of the
Network Provider’s Management Domain traffic can take through the unit. See
Application Examples for information regarding the Management Domain.
DIP Switch 1 = On for management on the EXT MGMT port.
DIP Switch 2 = On for management on the DATA port.
DIP Switch 3 = On for management on the OPTICS or UPLINK port.