TC Electronic UpCon - Manual (Page 30)

Recalling, storing and deleting settings
26 UpCon
Recalling, storing and
deleting settings
The Library concept
The Library gives you access to all settings of
all parameters of the currently selected UpCon.
The highest organizational level of the Library is
a Bank. A Bank will hold either…
– 50 Scene presets or
– 50 Routing presets or
– 100 Engine presets.
Factory presets vs. user presets
When recalling presets, you will see that there
are two categories of presets: Factory presets
and User presets.
– Factory presets can only be recalled, but not
overwritten or deleted. If you change a Fac-
tory preset and you want to keep it, you have
to store it as a User preset.
– User presets can be recalled, edited and
stored, thereby overwriting the previous ver-
sion.
Library – Recall page
Library – Preset Recall page
Use the Library Recall page of the TC Icon soft-
ware to recall (load) previously stored settings
into the memory of the currently selected device.
All colored buttons and selected items on the
Recall page are colored in green.
To access the Library Recall page:
– If it isn’t already, select the device you want to
control using the Select page – see “TC Icon
modes: Base and Device operation” on page
17.
– Select the “Library” tab.
– Select the “Recall” page.
– Select the subpage for the setting type you
want to access:
– Scene – to recall a Scene preset
– Route – to recall a Routing preset.
– E(ngine) 1 or E(ngine) 2 – to recall an Engine
preset and use it for the currently selected
Engine.
– Select between Factory and User preset
groups by clicking the Factory or User button.
There are 8 Factory and 8 User preset groups,
with each group holding up to 8 presets.
– Select a preset you want to use.
– Click the large “Recall (Scene / Route / Engine)
Preset” button in the upper right corner to re-
call (activate) the selected preset.
The selected preset will be recalled.
Preset information
For many presets, additional information is
stored as part of the preset. When you select
such a preset, an inverted “Info” tag will appear
at the bottom of the large Preset Recall button.
– Click the Info tag to display additional informa-
tion about this preset in a modal dialog.
– Click the OK button do close the dialog.
Library – Store page
Library – Scene Store page
Use the Library Store page of the TC Icon soft-
ware to store (save) settings to a memory bank.
You can only store settings as User presets. Fac-
tory presets cannot be overwritten.
All colored buttons and selected items on the
Store page are colored in red.
To access the Library Store page:
– Select the “Library” tab.
– Select the “Store” page.