Turbosmart BOOST CONTROLLERS – ELECTRONIC - e-Boost2 (2005-current) – Complete User Manual - Manual (Page 21)

www.TURBOSMARTONLINE.com
21
SSA (Sequential switching function A): Allows you to sequentially switch between different boost settings. This switch logic could be
applied in a situation where you want to have a different boost level in each gear.
 Earthing the green wire with a switch will scroll up a single set point.
 Earthing the green wire again will switch up another single set point.
 The maximum number of set points that can be switch up to is determined by nSP in the setup menu.
 Once the maximum set point is reached through switching further switching not increase the set point any higher.
 Earthing orange wire with a switch will reset and return to SP1.
SSB (Sequential switching function B): Sequential Switching Function B allows you to sequentially switch up and down between
different boost settings using external switches. This switch logic could be applied in a situation where you want to have a different
boost levels in each gear.
 Earthing the green wire with a switch will switch up a single set point.
 Earthing the green wire again will switch up another single set point.
 The maximum number of set points that can be switch up to is determined by nSP in the setup menu.
 Once the maximum set point is reached through switching (note: will only switch up to SP6).
 Earthing orange with a switch will wire switch down a single set point.
 Earthing the orange wire again will down another set point. (note: will only switch down to SP1).
Boost Curve
SP1
SP2
SP3
SP4
Ground Orange
Wire- Reset to SP1
Ground Green W ire
- trigger up SP
BOOST
SP5
SP6
TIME
Example Boost
SP1
Ground Green
Wire- trigger up SP
Ground Orange
Wire- trigger down
SP
SP2
SP3
SP4
SP5 BOOST
SP4
SP5
SP6
SP2
SP1
SP3
TIME