Turbosmart BOV ADAPTERS - Nissan Pulsar_Sunny GTiR User Manual
Pulsar gtir blow-off valve adaptor instructions, Undo
PULSAR GTiR BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Turbosmart Pty Limited P.O.Box 264 Croydon, NSW, 2132 Australia ABN: 69 081 069 794
Ph: +(612) 9798 2866 Fx: +(612) 9798 2826 Email: [email protected]
PART NUMBER
FG-ADM-GTiR
IMPORTANT NOTES ON FITTING YOUR BOV PULSAR GTiR ADAPTOR
Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.
ADAPTOR KIT CONTENTS
Please check that the following items have been provided in your Pulsar GTiR adaptor Kit.
Note:
This Pulsar GTiR Adaptor readily accepts the following Turbosmart BOVs:
Quantity Description
Use
1
GTiR Adaptor
Designed to fit the Pulsar GTiR factory turbo hose
1
29mm Blanking Plug
To blank off the factory return hose
1
50mm hose clamp
Secures the GTiR Adaptor to the turbo hose
1
Pre-assembled tee-piece and
Silicon hose assembly
Connects the 4 throttle body vacuum fittings to the Turbosmart BOV fittings
1
6mm hose blank
To blank off the factory vacuum/boost line
1
6mm hose spring clamp
Secures the 6mm blanking plug on the factory vacuum/boost line
5
5mm hose spring clamp
Secures the 4 throttle body vacuum fittings and Turbosmart BOV fitting
1
Atmospheric spring
Recommend when using an
atmospheric venting Type II or III BOV - see fitting notes
following the kit installation instructions
Blow Off Valve Name
Part No.
Blow-off Valve - Vee Port
FG-BOV-002VP
Blow-off Valve - Supersonic
FG-BOV-003SS
Blow-off Valve – Plumb Back
FG-BOV-003PB29
Blow-off Valve – Dual Port
FG-BOV-003DP29
FITTING YOUR BOV PULSAR GTiR ADAPTOR
Note: Please thoroughly read and understand both these instructions and the fitting instructions supplied with your
BOV before commencing this installation.
Step 1. Undo and remove the 3 bolts on the left hand
side of the intercooler cover with a 10mm spanner or
socket.
Step 2. Undo and remove the 2 bolts on the right hand
side of the intercooler cover with a 10mm spanner or
socket. Then remove the intercooler cover.
Step 3. Using an 8 mm spanner or socket, loosen
the bottom factory hose clamp securing the
factory hose coupler to the bottom intercooler
hose fitting.
Step 4. Using an 8 mm spanner or socket, loosen the
top factory hose clamp securing the factory hose
coupler to the top intercooler hose fitting.
Undo
Undo