Turbosmart BOV ADAPTERS - Nissan 180SX – SR20DET - Manual

SILVIA / 180SX-SR20 BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia Ph: +61(2) 9798 2866 Fax: +61 (2) 9798 2826 Email: [email protected]
USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA Ph: (760) 727 7610 Fax: (760) 727 7963 Email: [email protected]
PART NUMBER
FG-ADM-180SXSR
FG-ADA-
asfsdfdfsdfsdfsdf180
SR2srSRSX2020S20R
20
IMPORTANT NOTES ON FITTING YOUR 180SX-SR20 ADAPTOR
Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.
ADAPTOR KIT CONTENTS
Please check that the following items have been provided in your 180SX-SR20 Adaptor Kit.
Quantity Description Use
1 180SX SR20 Cross-over Pipe Joining pipe from intercooler to turbo
2 70mm hose clamps Secures SR20 Adaptor to factory pipes
1 Pre-assembled tee-piece and Silicon
hose assembly Connects to the intake manifold nipple, Turbosmart BOV and existing factory
boost/vacuum line
1 5mm spring clamp Secures the 5mm Silicon hose over the Turbosmart BOV
1 6mm hose clamp Secures the 6mm Silicon hose onto the intake manifold nipple
2 25mm Blanking Plug To blank off the factory BOV return hose
4 32mm Hose Clamps To secure the blanking-plugs
Note: The 180SX-SR20 Adaptor readily accepts the following Turbosmart BOVs:
Blow Off Valve Name Part No.
Blow-off Valve - Vee Port FG-BOV-002VP
Blow-off Valve - Supersonic FG-BOV-003SS
Blow-off Valve - Megasonic FG-BOV-003MS
To install a Dual Port or Plumb Back BOV, fabrication will be required to connect the plumb-back fitting to the intake.
FITTING YOUR BOV 180SX-SR20 ADAPTOR
Note: Please thoroughly read and understand both these instructions and the fitting instructions supplied with your
BOV before commencing this installation.
Step 1. Undo the hose clamps on the factory
crossover pipe.
Step 2. Remove the factory pipe.