Turbosmart BOOST CONTROLLERS - Dual Stage Boost Controller User Manual
How to install your boost controller
1
------------------------------------------------------------------------------------------------------------------------
ABOUT THIS PRODUCT
Thank you for purchasing your new DSBC. This new model now has some great new features. These include:
•
2 ramp rates of boost to give you the option of a fast rise in boost or a slightly tame rise for more sensitive setups.
•
A wider boost adjustment range for wastegates with low spring base pressures.
IMPORTANT NOTES ON YOUR BOOST CONTROLLER
•
Use only silicone hose that is the correct size and pressure rating for your application when fitting your boost controller
– other
hoses will be effected by heat and will eventually crack or split which could cause excessive boost pressure and engine damage
•
Ensure that all plumbing is secured with clamps
•
Your boost controller should be mounted at least 100mm from any heat source
•
A Turbosmart Fuel Cut Defender may need to be used in conjunction with your boost controller
– refer t
•
The boost dials have a left handed thread, be sure not to over tighten as this will damage the boost controller
RECOMMENDATIONS
•
Turbosmart recommends that the Air Fuel ratio is checked once boost pressure is set
•
Turbosmart recommends that boost pressure is set using a Dynamometer and not on the street
•
Turbosmart recommends that a accurate boost gauge be permanently fitted to the vehicle
•
Turbosmart recommends that your boost controller is fitted and adjusted by an appropriately qualified technician
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR BOOST CONTROLLER
TOOLS REQUIRED
General mechanic tools
ELECTRICAL CONNECTION
The white wire is positive and the Black wire is negative
Supplied wiring can be split if needed to extend wiring to the appropriate areas
Extend the white wire using the supplied black with white trace wire through the supplied switch to a fused 12 volt ignition
supply
– Important, failure to connect to an ignition supply may cause the battery to go flat and may result in damage to the
product
Check that the power source can accept an additional 1amp load
Connect the black wire on the unit, with crimp supplied, to a solid ground point on the chassis. Use the supplied black wire to
extend if needed.
Product Name:
Dual Stage
Product Description:
Dual stage boost controller
Product Number:
TS-0105-1001/TS-0105-1002