Turbosmart BOOST CONTROLLERS – ELECTRONIC - e-Boost2 (2005-current) – Complete User Manual - Manual (Page 2)

www.TURBOSMARTONLINE.com
2
Pin (Security Pin number) ......................................................................................................... 30
Ser (Serial Number) .................................................................................................................. 30
Sol (Solenoid Cycle) ................................................................................................................. 30
ZEr (Gauge Zero)...................................................................................................................... 30
rES (Reset)................................................................................................................................ 31
VEHICLE WIRING DIAGRAMS ................................................................................................ 31
TROUBLESHOOTING ................................................................................................................ 37
Parts list
Quantity Part Description
1 e-Boost 2 Head unit Boost controller
6ft 4mm poly tube Connecting vacuum/pressure to e-Boost head unit
6ft 3mm Silicon vacuum tube Connecting vacuum/pressure to e-Boost head unit
6ft 5mm Silicon vacuum tube Connecting pressure source to solenoid and actuator
1 8 pin wiring loom Wiring loom
1 3 Port solenoid For controlling air pressure to wastegate actuator
3 1/8 NPT pressure nipples For connecting pressure lines to the solenoid
1 Fuse holder with 5amp fuse For connecting power to e-Boost loom
1 5/32 hose tee piece
Splicing existing vacuum line for signal to e-Boost head
unit
2 1/4 - 3/16 hose reducer Connecting 3mm - 5mm vacuum tube
1 Poly tube - 3mm joiner Connecting 4mm poly tube to 3mm silicon vacuum tube
1 Solenoid mounting bracket For mounting solenoid to chassis
2 M3 X 20 Socket head screws For mounting the solenoid to the bracket
1 Panel mount bracket Mounting e-Boost head unit to a panel
1 M6 X 20 Grub screw For panel mount bracket
1 M6 Half nut For panel mount bracket
1 M6 Washer For panel mount bracket
4 3mm spring clamps For securing 3mm vacuum hose to fittings
6 5mm spring clamps For securing 5mm vacuum hose to fittings
1 6mm crimp on connector For securing the ground wire to the chassis
1 100mm heat shrink For insulating joined wires
10 100mm cable ties For securing hoses and lines
1.8m 2 core cable For connecting the wiring loom to solenoid
2
M6 X 25mm socket head
screw
Mounting the solenoid bracket to chassis
2 M6 Nyloc nuts Securing solenoid bracket to chassis