Turbosmart BLOW OFF & BYPASS VALVE KITS - Dual Port for: Subaru WRX (08+), Liberty_Legacy, Mazdaspeed_MPS 3, 6, CX7 User Manual
Setting the flange to suit different vehicles, How to install your bov
1
------------------------------------------------------------------------------------------------------------------------
Suitable for: Mazda MPS (Mazdaspeed) 3, 6, CX7, Subaru WRX’08+ (excluding WRX STI 08),
Legacy/Liberty GT’03 - current.
IMPORTANT NOTES:
•
This Blow-Off Valve does NOT fit the 2008 WRX STi. Please refer to
www.turbosmartonline.com
for product updates.
•
Please thoroughly read and understand these instructions before commencing this installation.
•
The thread on the cap for the vacuum source is AN#3. The standard swivel nipple can be changed to a AN#3 fitting if desired.
RECOMMENDATIONS
•
Turbosmart recommends that your Blow off valve (BOV) is fitted and adjusted by an appropriately qualified technician
•
Turbosmart recommends that a boost gauge be permanently fitted to the vehicle
------------------------------------------------------------------------------------------------------------------------
SETTING THE FLANGE TO SUIT DIFFERENT VEHICLES
The BOV flange can be rotated to suit different vehicles. There are currently 2 setting notches; setting notch 1 for the Mazda MPS range
and setting notch 2 for the MY08 WRX/Liberty GT. The BOV comes preset to setting notch 1. The flange can be rotated by loosening
the securing screws at the bottom with a 3mm allen key. Do not remove the screws, only loosen them. Rotate the flange until it lines up
with the desired indicator groove. Re-tighten the screws.
HOW TO INSTALL YOUR BOV
Please check that the following items have been provided in your MPS/WRX Dual port kit.
Quantity
Description
Use
1
MPS/WRX Dual port BOV
MPS/WRX Specific blow off valve
1
Blanking plug
To blank off a port to convert the BOV to full atmospheric or plumb back
1
Gasket
To seal the BOV to the intercooler pipe
1) Installation on a Mazda MPS (Diagrams are from a Mazda 3 MPS) – Setting notch 1
1) Remove the engine cover by removing the two securing screws/plugs.
Product Name:
MPS Dual Port
Product Description:
Model-Specific Dual Port BOV
Product Number:
TS-0205-1009
Setting notches
Indicator Grooves
MPS = ο
WRX = οο