Turbosmart BOV ADAPTERS - Nissan Skyline R33 Plumb Back User Manual
Skyline r33 gts-t plumb back kit instructions, Important
SKYLINE R33 GTS-T PLUMB BACK KIT INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia
Ph: +61(2) 9798 2866
Fax: +61 (2) 9798 2826
Email:
USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA
Ph: (760) 727 7610
Fax: (760) 727 7963
Email:
PART NUMBER
FG-ADM-R33PBK
IMPORTANT NOTES ON FITTING YOUR SKYLINE R33 BOV PLUMB BACK KIT
Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.
IMPORTANT!
You will also need the following adaptor kit for this Plumb Back or Dual Port BOV installation:
Adaptor Kit Name
Part No.
Skyline R33 Adaptor Kit
FG-ADM-R33
ADAPTOR KIT CONTENTS
Please check that the following items have been provided in your R33 Plumb Back Kit.
Qty
Description
Use
1
R33 Elbow
Used to connect the BOV to the R33 Adaptor
1
32mm ID Silicon bend
Used to connect the BOV plumb back fitting with the factory return pipe
2
40mm hose clamps
Secures the Silicon bend assembly to the BOV plumb-back fitting and factory return pipe
Note:
This R33 Plumb Back Kit accepts the following Turbosmart BOVs:
Blow Off Valve Name
Part No.
Blow-off Valve - Plumb Back
FG-BOV-003PB32
Blow-off Valve - Dual Port
FG-BOV-003DP32
FITTING YOUR BOV R33 PLUMB BACK KIT
Note: Please thoroughly read and understand these instructions, the Skyline R33 Adaptor instructions and the fitting
instructions supplied with your BOV before commencing this installation. These instructions follow on from Step 9 of
the R33 Adaptor instructions included with the R33 BOV Adaptor Kit.
Step 10. Install your Turbosmart BOV onto the R33
Elbow by following the instructions included with the
BOV.
Step 11. Install the R33 Elbow onto the R33 Adaptor.
Step 12. First loosen the 3 lock nuts using an 8mm
socket. Then secure the 3 grub screws onto the R33
Adaptor using a 2.5mm Allen key. Tighten the 3 lock
nuts to secure the assembly using an 8mm socket.
Step 13. Connect the Silicon bend to the BOV fitting
and factory return pipe. Secure each fitting with a
40mm hose clamp supplied.
72mm
Connect to Factory
Return Pipe
Connect to
BOV fitting