Grain Systems Tanks PNEG-1095 - Manual (Page 60)

6. Installation
60 PNEG-1095 FCDL 4.00" Corrugation Externally Stiffened Grain Bin
Options for 2 Ring Door
Inner Door Auger Hood
12' (3.66 m) - 24' (7.32 m) Diameters Only
1. Remove bolts, lock washers and nuts along each side of large square opening on the inner
door panel.
2. Position auger shield as shown in Figure 6P and bolt to underside of top angle with bolt heads under
shield. Replace bolts, lock washers and nuts through inner door panel and auger shield.
(See Figure 6P.)
3. Attach inner door panel to inner bin door and outer door panel to the outer bin door.
Figure 6P
CAUTION
Improperly unloading grain through door opening may cause grain bin failure.
Unloading directly through the door opening should be limited to grain bins no
larger than 24' (7.32 m) diameter and grain depths no greater than 18' (5.49 m).
Unloading from the door opening should be done only with use of an auger
hood with the auger inserted through the opening all the way to the center
of the bin.