Rough Country 770S User Manual
Page 4
FRONT INSTALLATION INSTRUCTIONS
1. Prior to installing this kit, with the vehicle on the ground, measure the heights of your vehicle. This measurement can
be recorded from the center of the wheel straight up to the top of the inner fender lip. Record the measurements.
LF:____________, RF:__________, LR:___________, RR:___________.
2. Place the vehicle in park on a smooth and level surface. Place the floor jack under the front cross member of the
vehicle and raise the vehicle. Place jack stands under the frame rails behind the front wheel wells and lower the
frame onto the stands. Remove the jack, set emergency brake and chock rear wheels.
3. Remove the front wheels.
4. Remove the front skid plate and skid plate support bracket using a 12mm socket. Retain stock hardware for re-
useSee PHOTO 1.
5. Using a 12mm socket, unbolt the brake line bracket from the knuckle. Retain factory hardware for reuse. See
PHOTO 2.
PHOTO 1
PHOTO 2
6. Using a 12mm socket, unbolt the brake line bracket from the frame. Retain factory hardware for reuse. See PHOTO
3.
7. Remove the ABS bracket from the knuckle using a 12mm socket. Retain factory hardware for reuse. See PHOTO 4.
PHOTO 3
PHOTO 4