Rough Country 770S - Manual (Page 11)

56. Using the 3/8” bolts, washers and lock washers from 1770bag4, bolt the sway bar to the new bracket. See PHOTO
41.
57. Using a 9/16” socket, bolt the stock front sway bar link to the sway bar and knuckle using the stock hardware. See
PHOTO 42.
PHOTO 41 PHOTO 42
PHOTO 43
60. Attach the top of the front skid plate to the factory location, using the factory hardware. See PHOTO 45.
61. Locate the factory drain plug from the stock skid plate and install into the new bottom skid plate. See PHOTO 46.
PHOTO 44
PHOTO 45 PHOTO 46
58. Attach the bottom skid plate to the rear cross member with the 3/8” bolts from 1770bag6 using a 9/16” socket. See
PHOTO 43.
59. Attach the front skid plate to the front cross member, overlapping the bottom skid plate lip, using the 3/8” bolts from
1770bag6. Tighten using a 14mm socket. See PHOTO 44.