Rough Country 770S - Manual (Page 10)

45. Using a 5mm allen wrench and factory hardware, reinstall the ABS sensor to the knuckle. See PHOTO 35.
46. Reinstall the ABS bracket to the knuckle using factory hardware and a 12mm socket. See PHOTO 36.
PHOTO 35
47. Reinstall the brake line bracket back to the knuckle using factory hardware and using a 12mm wrench. See PHOTO
37.
48. Using a 35mm socket reinstall the factory axle nut, torque to 174ft. lbs. Reinstall the factory cotter pin and pal nut.
49. Reinstall the factory dust cap.
50. Using a 12mm wrench install the new brake line bracket using the stock hardware for the stock hole and the sup-
plied 5/16” bolts, nuts and washers from 1770bag5. See PHOTO 38.
PHOTO 36
PHOTO 37 PHOTO 38
51. Using a 19mm wrench, reinstall the outer tie rod to the knuckle using stock hardware.
52. Using a 19mm socket and wrench torque the lower strut bolt to 100ft. lbs.
53. Repeat steps 35-52 on the opposite side.
54. Insert the 3/8” nuts from 1770bag4 into the sway bar relocation bracket as shown in PHOTO 39.
55. Place bracket into the original sway bar mounting location, using the stock bolts and a 14mm socket, bolt the factory
bolts back into the factory holes. See PHOTO 40.
PHOTO 39 PHOTO 40