VEGA RS232_Ethernet connection - Manual (Page 57)

57
11 Measured value transmission via SMS
RS232/Ethernet connection • VEGAMET 391/624/625, VEGASCAN 693, PLICSRADIO C62
30325-EN-130701
11 Measured value transmission via SMS
11.1 General information
Sending an SMS is only possible with signal conditioning instruments
with serial interface in conjunction with modems supported by VEGA.
A GSM modem and a conventional telephone network modem are
available for the analogue telephone connection. To send an SMS,
the signal conditioning instrument dials into an SMS Service Center
(SMSC): Via this SMS Service Center the SMS is the transferred to
the subscriber (e.g. mobile phone).
Note:
To set up the SMS function, PACTware with the corresponding DTMs
is required.
11.2 Settings for SMS transmission
Open the suitable DTM in PACTware and select the menu item
"Device settings - SMS" for configuration of the SMS function. As
basic setting, the connected modem and the requested SMS provider
(SMSC) are selected.
If the SMS should be transmitted via the conventional telecommuni-
cation network, you will need an analogue telephone connection with
direct outward dialing and the Phoenix Contact PSI data/fax modem
(order no.: MODEM.JX)
If transmission is made via GSM, the Siemens TC35i GSM cellular
phone modem must be used (order no.: MODEM.FX). For this you
will need a GSM contract. Make sure that there is sufficient network
coverage by the provider. Furthermore the PIN of the used SIM card
must be deactivated.
From the provided list you can select the suitable provider (SMSC). If
the requested provider is not listed, you can select "User-defined" and
enter the respective phone number (only Siemens TC35i) in the field
"SMSC phone number". With Poenix Contact PSI Data/Fax Modem
you can only use the providers available in the list.
In this field, the phone number of the provider selected previously
from the list appears. After having selected "User-defined" you can
enter the phone number of the requested provider.
Further SMS settings are carried out under the menu item "Event list".
These are:
•
"Phone number:" Phone number of the SMS addressee
•
"Event type:" Time, measured value or status-controlled
•
"Contents of messages:" Measured value or status
•
"Actuator for transmission:" Time, interval, exceeding/underrun-
ning the measured value
Modem
Provider
SMSC phone number
SMS configuration as-
sistent