5 setup – VEGA VEGAMET 614 User Manual

Page 18

Text mode
Original mode

VEGAMET 614

Setup

5 Setup

• Set the VEGAMET instrument address on

the circuit board by means of the rotary
switch (only necessary, if several
VEGAMET are connected on the DISBUS).

• Install VEGAMET.
• Connect sensor and power supply.
• After switching on, the display indicates for

approx. 10 secs the instrument type and
the software version, e.g. "MET 614
V1.12“.

• If a measurement loop has not yet been

configured, the display shows "Configura-
tion“, the red failure LED also lights. In this
case, proceed as described under "6.1
Configuration of measurement loop“.

• If a measurement loop has been

configured, the display shows a value, e.g.
"TAG-No. 1 21.8 %“.You can now carry out
the settings as described in the chapter "6
Settings in the reduced menu“.