VEGA VEGAMET 514V - Manual (Page 35)

VEGAMET 514V 35
Settings in the "extended menu“
7.8 Conditioning
The menu items " Scaling “ and " Integration
time “ correspond to the menu items in the
"reduced menu“ (see appropriate chapter).
The menu item " Density… “ is optionally dis-
played when under "Configuration measure-
ment loop“ the appropriate sensor type has
been selected. The density value must,
before adjustment with medium, be so ad-
justed that it corresponds to the value of the
medium (see also chapter "Adjustment“).
The conditioning of VEGAMET can be
adapted to different vessel forms. The follow-
ing linearisation curves are available:
- linear (factory setting)
- horiz. cylindrical tank
- spherical tank
- Lin-curve 1
- Lin-curve 2
- Lin-curve 3
Lin-curves 1 … 3 can be edited by your-
self (see appropriate chapter).
After a scaling or linearisation, the required
output must be coordinated to the scaled or
linearised value (menu item "prop. to..." and
"Unit...") in the menu range "Parameter adjust-
ment outputs".
Under Meas. value limitation you can ex-
clude negative values.
Failure mode Standard
means that with a sensor current of 3.6 mA or
21 mA the fail safe relay responds.
Failure mode >110%
also causes a fault signal when a meas. value
of more than 110 % or less than -10 % is
reached.
Param.
TAG-
No. 2
like TAG-No. 1
Param.
TAG-
No. 1
Adjust-
ment Signal
condi-
tioning
TAG -
No. 1
%
xx,x
Scaling Lin.
curve
linear
0%
corres-
ponds
0
100%
corres-
ponds
1000
Integr
ation
time s
0
Den-
sity in
Kg/dm
3
1,000
Meas.
value
limita-
tion
Deci-
mal
point
888,8
prop.
to
unde-
fined
Unit
– –
nega-
tive
values
yes
Failure
mode
Stan
dard
cylindrical tank
etc.
>110%