VEGA VEGAMET 514V - Manual (Page 29)

VEGAMET 514V 29
Settings in the "extended menu“
0
40
100%
40 100%
Meas. values in %
Taster
tared course
actual course
actual measured values
tared measured values
7.2 Tare
With the function "Tare“ a measured value
beginning at 0 % is created from the actual
measured value. The tare function can be
started via a key connected to correction
signal input 4.
The following steps are necessary to activate
the tare:
• Connect a key (closer) to input 4.
• Choose in the menu item " Input from “
(under the menu item " Tare “) input 4.
• Assign the tared values in the menu item
" Unit “ to the requested output (e.g. cur-
rent, volt, DIS, PC/DCS output, MET indica-
tion).
If you want to delete the tare function again,
you first have to cancel the tare in the menu
item "
Unit “. Then you have to cancel the
allocation of the correction input (input 4)
under the menu item "
Tare “.
Confi-
gura-
tion
Config
inputs Config
meas.
loop
TAG 1
Level
Appli-
cation
Level
Param.
TAG-
No. 1
TAG -
No. 1
%
xx,x
Tare
Input
from
In-
put4
Param.
TAG-
No. 1
Adjust-
ment Signal
condi-
tioning Out-
puts
Cur-
rent
out-
puts Volt
out-
puts
Volt
output
1
prop.
to
Per-
cent
Unit
Tare
%
TAG -
No. 1
%
xx,x
Volume Tare
V%