Motorhome - additional important information, Important notes – Spicer Drive Axles Application Guidelines User Manual
Page 33

AXAG-0200 June 2009 33
Motorhome - Additional Important Information
Important Notes
1.
The following optional components are approved by this Guideline. All options may not be available on every axle model.
a. Low Maintenance Wheel Ends (
2.
The use of
differentials in any drive axles will result in the exclusion of
from warranty consideration.
Certain other carrier components may also be excluded from warranty consideration if their failure is deemed to be the result
of NoSPIN use. Depending on axle loading, the NoSPIN can cause all torque to be directed to one axle shaft resulting in
overload and potential failure. “NoSPIN
®
” is a registered trademark of Tractech, Inc., a Division of Dana Corporation.
3.
Drive Axle application approval and allowable gross axle weight is based on the vehicle suspension selected. Dana CVP is
not responsible for the durability of any bracket attached to the axle housing(s) unless produced by Dana Holding
Corporation. In addition, Dana CVP is responsible for the integrity of the bracket attachment only if the bracket is installed
by Dana or if the bracket is installed by the vehicle manufacturer following detailed recommended procedures provided by
Dana through prior agreement.
4.
It is the responsibility of the vehicle manufacturer and/or the dealer to accurately convey all approved axle loading
information to the body builder if the chassis is sold as incomplete. It is also the responsibility of the final vehicle builder to
insure the assigned tagged values for
do not exceed those limits approved by this vocational
Guideline. Dana is not responsible for non-compliance to this request.
5.
Vehicle testing of any nature voids the warranty on Spicer
®
drive axles.
6.
For specific warranty coverage for the Motorhome vocation, see
7.
For approval of Spicer Transmission, Spicer Clutch, Spicer
®
Driveline, Bendix
®
Brake, and all other components contact