Spicer Single Drive Axles Service Manual: 34DS, 34RS, 38DS, 38RS, DS340, RS340, DS380, RS380, DS400, RS400, DS3 - Manual (Page 74)

Differential Carrier Overhaul (Forward and Rear Axle)
71
Disassembly Drive Pinion
Note: Dana drive axles may be equipped with either slip-fit or press-fit outer pinion bearings. Procedures are contained in-this
section for disassembly of both types.
1
2
3
4
5 6 8
9
10
12 13
7
11
14
15
16
1 Pinion pilot bearing
2 Drive Pinion
3 Bearing cone (inner)
4 Spacer washer
5 Bearing spacer (variable)
6 Bearing cup (inner)
7 Lockwasher
8 Bearing cage shim
9 Bearing cage
10 Bearing cup (outer)
11 Cage capscrew
12 Bearing cone (outer)
13 Oil seal
14 Input yoke
15 Flat washer
16 Pinion nut
Rear Axle Pinion Illustrated.
Forward Axle Pinion Illustrated.
ïD341, 381(P), 401-P, 402(P), 403(P), 451-P use self-locking or slotted nut and roll pm.
Metric self-locking nuts used as of 1-3-95.
D340, 380(P), 400-P use self-locking nut only.