EVS XS Version 11.01 - November 2012 Configuration Manual - Manual (Page 89)

Warning
Some video formats allowed on an XS server create clips that are not compatible
with previous hardware. When an incompatible format is selected, a warning will
be issued at application startup. In addition, the video format information
displayed on the Server tab of the Multicam Configuration window indicates any
incompatible information.
3.3.3. Phase Definition Settings
Introduction
The Phase Definition settings are available on the Server tab in the server-based
application (1st page) and web-based interface in the advanced mode.
The Phase Definition settings are highlighted in the screenshot of the server-based
application shown below:
SD (Standard Definition)
Description Allows adjusting the digital main phase of the mainframe for
the standard definition. The value is adjusted by steps of half
pixels.
The values depends on the genlock type (See section "Video
and Reference Settings" on page 69).
Values • If the Genlock type is set to ‘Blackburst’, the main phase
for SD can be adjusted by steps of half pixels (37 ns)
between - 12000 ns and +15000 ns.
• If the Genlock type is set to ‘Tri-Sync’ (only possible in HD
resolutions), the main phase for SD can be adjusted by
steps of half pixels (37 ns) between - 30000 ns and
+32000 ns.
79 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B