EVS XS Version 11.01 - November 2012 Configuration Manual - Manual (Page 36)

Settings
The MTPC board connection settings are described in the table below:
Setting Description
IP Address Specifies the IP address to connect to the port #1 of the MTPC board on
the server. The IP addresses 0.0.0.0 and 255.255.255.255 are not
allowed.
Subnet Mask Specifies the range of logical addresses within the address space
assigned to the MTPC board connection.
Default
Gateway Specifies the IP address of the router on the network that the MTPC
board can use as an access point to external networks.
How to Set the LAN PC
To set up the LAN PC on the EVS server, proceed as follows:
1. In the Multicam Setup window, press L to call the Set LAN PC address command.
The following window opens:
2. In this window, type the IP address, subnet mask, and default gateway. Use the TAB
key to move from one field to the other.
3. Press ENTER to validate the definition of the LAN PC settings.
The LAN PC settings will automatically be taken into account when you launch a
configuration line.
2.3.5. Setting the Server Date and Time
Introduction
The Set Date and Time command allows you to adjust the system time & date from the
Multicam Setup window in the server-based application. This is not available in the web-
based interface.
Note
When you have just launched a configuration, a window displaying the system
date and time gives you another opportunity to modify these parameters.
XS Server - Version 11.01 - Configuration Manual
2. Multicam Setup 26