EVS XS Version 11.01 - November 2012 Configuration Manual - Manual (Page 111)

IN1 XX% Loop
Warning
A change to this parameter requires an application reboot (ALT+Q from the
operational windows) to be taken into account.
Description This parameter contains two types of information on the
specified recorder:
Recording Capacity: XX% percentage of the disk space
allocated to each channel.
Loop / No Loop: indicates whether the Loop Recording
parameter is enabled or not.
Values The following values are possible:
• Recording Capacity: The value is defined by the user.
The total of all values must not exceed 100%.
By default, the recording capacity is evenly distributed
among all recorders.
Example: In a 2 REC 4 PLAY configuration, the recording
capacity will be 50% for each recorder by default.
• Loop / No Loop:
• The value directly depends on the Loop Recording setting:
◦ If the Loop Recoding is enabled, the value will be
'Loop'.
◦ If the Loop Recording is disabled, the value will be 'No
Loop'.
Mix on One Channel Feature
Introduction
The Mix on one channel feature allows the use of the second channel of a codec module
(J3) to provide mixing with a single codec module. This function can be enabled for each
individual play channel. This feature is available for playlists only, in Spotbox and
Multicam LSM configurations and with all controllers.
Conditions
The Mix on one channel feature is available in the following conditions:
• with a valid license code 31
• with V3X boards
• with a sufficient bandwidth (275 MBytes/sec with XS 6U, and 110 MBytes/sec with
XS 5U)
101 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B