EVS IP2Archive Configurator Version 1.0 - July 2013 User Manual - Manual (Page 31)

How to Add a Single Tape ID
To add a single tape ID, proceed as follows:
1. Click the Add button.
◦ If tape set ID 0 is selected, a warning message appears. This is because normally
no tapes are assigned to tape set 0.
Click No to abort the operation and select a different tape set ID first.
◦ If tape set ID 0 is not selected, or if you click Yes, the Add Tapes dialog box
appears.
2. Select the Single Tape radio button.
3. Enter the tape ID.
4. Click Add to add the tape ID to the list of tape IDs or Cancel to cancel the operation.
How to Add a Tape Range
To add a range of tapes, proceed as follows:
1. Click the Add button.
◦ If tape set ID 0 is selected, a warning message appears. This is because normally
no tapes are assigned to tape set 0.
Click No to abort the operation and select a different tape set ID first.
◦ If tape set ID 0 is not selected, or if you click Yes, the Add Tapes dialog box
appears.
IP2Archive - User Manual - Configurator Version 1.0
4. Configuring Connections 27