EVS Xfile Version 2.02 - February 2009 User Manual - Manual (Page 83)

Issue 2.02 D XFile Version 2.02 – User Manual
EVS Broadcast Equipment – February 2009
82
‘Restore Destination Mode’, on page 79).
6. You may switch to the Fast Publish mode by pressing the
(Fast
Publish) button.
7. Select other clips from the XFile list and repeat the operation.
Clips are sent to XNet. Depending on the number of clips, this operation can
take some time.
In the XFile list and XNet list, clips are highlighted in
• light yellow when the publish is scheduled
• light orange when the publish is done
The counter and the Publish column of the XFile list are updated as clips are
published.
To publish clips with Fast Publish, proceed as follows:
1. Press the Publish button to activate the mode.
2. From the XFile list, select the clip you want to publish.
To select multiple clips, do one of the following:
• To select a list of contiguous clips, press SHIFT and select the first
and last clips of the list.
• To select non-contiguous clips, press CTRL and select the clips.
• To select all the clips displayed in the XFile list, press CTRL + A.
The Select All command is also available via the contextual menu on
the list of clips.
3. Change the display of the XNet list to find one location.
4. Select the location to publish the clip(s) in the page, the bank and the
camera selection.
5. Press
(Fast Publish) to initiate the transfer of the selected clip.
6. If you have selected multiple clips, the XFile Multi-Publish window
opens: