EVS Xfile Version 2.02 - February 2009 User Manual - Manual (Page 23)

Issue 2.02 D XFile Version 2.02 – User Manual
EVS Broadcast Equipment – February 2009
22
If the values are coherent, press START: the System Config field is
replaced by the Session Config field.
3.2.2 S
ESSION
C
ONFIGURATION
A
REA
This field displays the current parameters and values saved to the
descriptive metadata of the MXF header and added to each clip. This data
can be modified for each session in the session configuration window.
3.2.3 S
TATUS
A
REA
The aim of this area is to check the hardware validity, the remaining
capacity of disks and to verify the compatibility between the software, the
drivers and the data recorded.
The system automatically starts the test processing. One after the other, the
different stages of the boot sequence are displayed in the Status window.
If an error occurs during one stage, write the message down and contact
EVS staff for support.
The last test is the connection to the XNet. If this stage is successful, the
XFile is ready to operate.
Press the Start button again to enter the application.