EVS GX Version 1.10 User’s Manual - Manual (Page 22)

Issue
1.10.D
GX server – Version 1.10 – User Manual
EVS Broadcast Equipment – September 2012
14
The schema below shows how the GX server needs to be cabled before switching it on.
The table hereafter briefly describes the connections highlighted on the schema:
# Description
1. Connect the power supply to mains.
Connect the second power supply to allow automatic power switching in case of
failure.
2. Connect the external controller to the RS422 port on the GX server.
3. Connect one or both of the GigE ports of the GX server to the local area network.
This will allow users to connect remotely to the GX server via the GX web interface.
See section 'Gigabit Port Configuration' on page 15.
4. Connect the KEY and FILL connectors to the video equipment that will perform the
keying of the GX outputs.
5. Connect the Genlock feed to the GLK connector to make sure the video signals
from the GX server are synchronized in your setup.
The mouse, keyboard and VGA connectors at the back of the server also allow users to
directly connect to the server, mainly to perform tests and checks.