EVS Xfile Version 2.13 - July 2010 User Manual - Manual (Page 29)

Issue 2.13.D XFile Version 2.13 – User Manual
EVS Broadcast Equipment – July 2010
20
Three conditions are required to validate the Archive status:
1. Before the Autobackup session, place a checkmark in the following box:
2. Set the ‘DEFAULT XFILE’ parameter in the Setup menu of your EVS video
server. (see Multicam documentation for complete information).
The label appears on the line of the EVS video server if the
‘DEFAULT XFILE’ has been correctly defined.
3. Activate the AUTOBACKUP by pressing the
button in the
XFile main window.
Note
The Default XFile setting allows the user to initiate the backup of a clip
from the EVS video server via the >ARCHIVE command (see Multicam
documentation for details).
The Archive Flag also initiates the backup of a clip as requested by
the >ARCHIVE command even if the Default XFile is not set, but the
Archive status on the EVS video server is not updated.
Time Range
The autobackup session can be defined for a specific duration.
Select the check-box to activate the time range filter and press one of the Time
Range Selection button to access this window: