EVS Xfile Version 2.13 - July 2010 User Manual - Manual (Page 22)

XFile Version 2.13 – User Manual
EVS Broadcast Equipment – July 2010
Issue 2.13.D
13
If the values are coherent, press START: the System Config area is replaced by
the Session Config area:
3.2.2 S
TATUS
A
REA
The aim of this area is to check the hardware validity, the remaining capacity of
disks and to verify the compatibility between the software, the drivers and the data
recorded.
The system automatically starts the test processing. One after the other, the
different stages of the boot sequence are displayed in the Status window.
If an error occurs during one stage, write the message down and contact EVS staff
for support.
The last test is the connection to the XNet.
Note
In GBE Only mode, a longer starting sequence is needed to ping all the
servers.