EVS IPWeb Version 1.0 - June 2013 User Manual - Manual (Page 68)

To activate the Auto Send mode for a bin, proceed as follows:
1. Click the tab corresponding to the bin for which you want to set the Auto Send mode.
2. Click the Auto Send button.
A window shows all the possible destinations.
3. Select one of the targets.
The target is flagged and the Auto Send button is highlighted:
4. Repeat steps 2 and 3 if you want to select an additional target.
Clips will be automatically sent to the selected target(s) as soon as they are put into the
bin.
The Auto send mode can be disabled in the same way it has been activated: follow steps
1 to 3 above. From the Select Target window, click the Clear Selection button.
8.3.4. Sending Bin as Clips
Purpose and Context of Use
Users will choose this mode when the clips gathered for their edit are not in a defined and
final order in the bin. For example, sequences obtained at different points in time and
collected as the best moments of an event can be put in the same bin but need to be re-
organized in the edit.
Transfer Limitation
If some clips from the bin do not have a hi-res element, all the clips will be transferred
except those ones.
How to Send all the Clips from a Bin Individually
All the clips from a bin can be sent to a target destination in the form of clips.
To do so, proceed as follows:
1. Click the tab corresponding to the bin for which you want to send all the clips.
2. Click the Send Bin button.
A menu is displayed.
3. Select Send Bin as Clips.
A window shows all the possible destinations.
4. Select one of the targets.
The clips transfer is initiated. In this case, individual transfer requests are sent for each
clip from the bin.
60 8. Publishing and Transferring Clips
EVS Broadcast Equipment S.A. - June 2013 Issue 1.0.A