EVS IPWeb Version 1.0 - June 2013 User Manual - Manual (Page 57)

6. Creating a Clip and Sending it to
a Bin
6.1. Introduction
As soon as a media has been loaded, users can create a new clip from this loaded media
thanks to the clip creation functions of the Player pane. A clip can be created from a
recording ingest or from an existing clip. An existing clip can be re-trimmed on the Player
pane, if it has not been protected.
Clips are sent to a bin as soon as they are saved. So, a bin must have been selected prior
to or at clip creation. See section "Sending a Clip to a Bin" on page 53.
6.2. Clip Settings
6.2.1. Introduction
Most of the settings cannot be defined from the IPWeb interface and are directly applied
from IPDirector.
The only setting that the user can configure from the IPWeb interface relate to auto-
naming of clip.
6.2.2. Defining Clip Autoname
The Autoname setting allows the user to define auto-naming rules for new clips.
To define a clip auto-name, proceed as follows:
1. Click the [username] button from the Toolbar.
A menu is displayed.
IPWeb - Version 1.0 - User Manual
6. Creating a Clip and Sending it to a Bin 49