American Magnetics 187 Self-Compensating Liquid Level Controller User Manual
Model 187 liquid level controller
Table of contents
Document Outline
- Cover Page
- Table of Contents
- Foreword
- 1 Introduction
- 2 Installation
- 3 Operation
- 4 Remote Interface Reference
- 4.1 SCPI Command Summary
- 4.2 Programming Overview
- 4.2.1 SCPI Language Introduction
- 4.2.2 SCPI Status System
- Figure 4-1. The Model 187 status system.
- Table 4-1. Bit definitions for the Status Byte reg...
- 4.2.3 Standard Event Registers
- Table 4-2. Bit definitions for the Standard Event ...
- 4.2.4 Alarm Registers
- Table 4-3. Bit definitions for the Alarm Condition...
- 4.2.5 Command Handshaking
- 4.2.6 Remote Units
- 4.3 RS-232/422 Configuration
- 4.4 IEEE-488 Configuration
- 4.5 Command Reference
- 4.6 Error Messages
- 5 Service
- 5.1 Model 187 Maintenance
- 5.2 Model 187 Troubleshooting Hints
- 5.2.1 The Model 187 does not appear to be energize...
- 5.2.2 The Model 187 does not remember the alarm se...
- 5.2.3 The Model 187 displays “Over/Under Flow”.
- 5.2.4 The Model 187 displays “Max Diel Exceeded”.
- 5.2.5 The liquid level unexpectedly drops rapidly ...
- 5.2.6 The liquid level unexpectedly rises rapidly ...
- 5.2.7 The USER and FACTORY calibrations do not yie...
- 5.2.8 The Model 187 is not responding to remote co...
- 5.3 Additional Technical Support
- 5.4 Return Authorization
- Appendix
- Index