Reference, Conventions – ACU-RITE 100S User Manual
Page 35

32
100S
Turning Reference Manual
REFERENCE
100S
uses positive and negative numbers to display the position of the
tool along each axis. The graphic below shows a typical setup for the
positive and negative count directions for the X-and Z-axes on a lathe.
All of the examples in this manual are based upon this setup.
X-axis:
The axis will move away from the
center for a positive count direction.
Z-axis:
The axis will move away from the
spindle for a positive count direction.
Count Direction
Conventions
This section identifies the standard conventions that apply to your
100S
system.
This manual is related to the following products: