ACU-RITE 100S - Manual (Page 26)

100S Turning Reference Manual
TROUBLESHOOTING
23
Keys not
working
properly
Error
messages (E2-
E56) appear
Causes vary
Invalid key press
Symptom
Recommended
Corrective Action
Probable Cause
Turn the system “off” and
then “on” again, using the
switch on the back of the
readout.
If an error (besides E1) is
still detected when the
system is powered up,
contact your 100S distrib-
utor for repair/replace-
ment
procedures. Refer to pgs.
26 - 27 for a list of error
messages.
Dashes
appear on
screen
(cont’d) Move the axis toward
the “0” position. As the
scale counts down, the
display will show the
correct position.
Display overflow
Turn the system “off” and
then “on” again, using the
switch on the back of the
readout. If an error (besides
E1) is detected when the
system is powered up, con-
tact your 100S
distributor for
repair/replacement
procedures. Refer to pg. 26-
27 for a list of error mes-
sages.
Error
message (E1)
appears Power loss occurred
This is a normal mes-
sage at power up. If the
message appears at any
other time during opera-
tion, a problem may
have occurred. Refer to
pg. 26 for details.