ACU-RITE 100S - Manual (Page 28)

100S Turning Reference Manual
TROUBLESHOOTING
25
Improper procedure Press the ENTER key after
each parameter value is
entered. If you press
another key instead, the
new value may not be
saved. Refer to pgs. 4 - 10
for proper procedures.
Setup does
not save
values
Numbers
don’t
appear/are
faded on the
display LED failure Turn the system “off” and
then “on” again, using the
switch on the back of the
readout. If this does not
correct the problem,
contact your
100S distrib-
utor for repair/replacement
procedures.
Symptom
Recommended
Corrective Action
Probable Cause