Operation setting the datum (absolute zero) – ACU-RITE 100S User Manual
Page 16

13
100S
Turning Reference Manual
OPERATION
Setting the Datum (Absolute Zero)
100S
allows you to measure both absolute and incremental dimensions.
A dimension measured from the point you define as the datum is an
absolute dimension. A dimension measured from any other point on
your print is an incremental dimension.
Datum, also known as absolute zero or workpiece zero, is the reference
point from which
100S
will base all of your part’s coordinates. When
the readout is in the ABS mode, it is actually measuring the distance
from the datum to the machine axis’ current position.
You will need to establish a datum for every job. Your datum may
already be identified on your print; if it isn’t, then establish a datum that
allows you to measure most of your part’s dimensions directly, with the
least number of calculations.
All of the dimensions in the drawing below are based from the datum.