Memory test -9 – Actron CP9449 ABS BrakeScan User Manual
Page 25
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 3 – 9
3
Using the Tool
Memory Test
The
Memory Test
will test the tool’s internal memory. Run the Memory Test
if the Tool:
• Has trouble displaying trouble code definitions.
• Operates abnormally.
From the
System Setup
menu:
1. Select Memory Test.
• Press the
UP or DOWN
arrow key until
Memory Test
is
highlighted.
• Press
ENTER.
✓
The tool reports its progress on the
bottom of the display.
❒
The
Memory Test
may take
several minutes to complete.
❒
The
Memory Test
results display:
• If no problems were detected,
then
PASS
is displayed
• If RAM fails, an error message is
shown.
• If ROM fails, a checksum is
shown.
• If the
Memory Test
fails, con-
tact Technical Support. The
phone number for Technical
Support is provided on the back
side of the title page.
2.
Return to
System Setup
.
• Press
BACK.
SYSTEM SETUP
=====================
Adjust Contrast
Display Test
Keypad Test
Memory Test
Tool Information
Program Mode
Memory Test
=====================
RAM: Pass
ROM: Pass
EEPROM: Pass