Actron Elite AutoScanner® CP9185 - Manual (Page 90)

Global OBD II Diagnostics
4 – 26 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
4 4
State OBD Check
The State OBD Check function is used to display a basic status of the
vehicles OBD system.
❒ Malfunction Indicator Lamp (MIL) Status
❒ Codes Found
❒ I/M Readiness
Erase Codes deletes DTCs and clears I/M Monitors from vehicle’s
computer module(s).
✓
The State OBD Check function has the following areas:
❒ MIL STATUS ON or OFF
❒ Number of Codes Found
❒ Number of Monitors OK
❒ Number of Monitors Inc
❒ Number of Monitors N/A
✓
State OBD Check should be done with the key on engine running
(KOER) due to showing MIL status.
✓
The number of codes found are only Generic OBD II codes and not
Pending codes.
✓
The number of Monitors that are either OK, INC or NA are only Since
DTCs Cleared and not This Drive Cycle.
✓
Refer to Read Codes and I/M Monitors for more detailed information
about the results.