Actron Elite AutoScanner® CP9185 - Manual (Page 172)

IMPORT (OBD II) Diagnostics
8 – 2 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
8
❒ Review Data
❒ Print Data
•I/M Readiness
•DTC (Codes)
•Pending Codes
•Freeze Frame
•O2 Monitor Test
•Diagnostic Monitor Tests
•Vehicle Info
•Playback
•State OBD Check
•Modules Present
✓
The following stored infromation can be reviewed for Import vehi-
cles. Refer to Review Data and Print Data in the Using the Scan
Tool section of this manual.
– Code Lookup
– Tool Setup menu
– English/Metric
– Display Contrast
– Beeper
– Setup User Key
✓
If an Error Message displays, make sure the OBD II connector is
securely attached, and the ignition key is on. Cycle the ignition key
to off for 10 seconds, then on. This may be required to reset the
computer. If required, select yes to try again. If the problem still
exists, refer to Error Messages on page 9-2.
Diagnostic Codes Menu
Items marked with “-” are covered in section 3 of this
manual. These items are not covered in this section.
❒ Diagnostic Codes Menu
❒ Read Codes
– Pending Codes
– Erase Codes
– View Freeze Data
– Code Lookup
– Review Data
– Print Data
– Tool Setup
IMPORTANT