Actron Elite AutoScanner® CP9185 - Manual (Page 142)

Ford Historic (OBD I) Diagnostics
6 – 20 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
6
Wiggle Test (EEC-IV Vehicles)
✓
The Wiggle Test, often referred to as the Continuous Monitor Test,
is used to locate intermittent electrical faults on EEC-IV vehicles.
When the test is activated, the Scan Tool beeps and displays a
message when a fault is present. If the problem is fixed or goes
away, the tone and message goes away. Refer to the applicable
service manual for circuits that can be tested.
✓
If the Alert was turned off in the Tool Setup menu, it will be
automatically activated for the Wiggle Test. Once the Wiggle Test
is complete, the alert returns to its previous setting.
From the On Demand Test Menu:
1. Select Wiggle Test.
•Use the UP or DOWN
arrow keys until Wiggle Test is
highlighted.
•Press ENTER .
✓
Either a KOEO or KOER Wiggle
Test can be run. If the vehicle
problem occurs while driving, the
KOER Wiggle Test is
recommended.
2. After making a selection.
•Press ENTER .
3. Perform the following:
1) Set parking brake.
2) Put Transmission in park (P) or neutral (N).
3) Turn A/C off.
4) Turn ignition key off. Wait 10 seconds.
5) KOEO: Turn key on engine off. Do not start engine.
6) KOER: Turn key on engine running and let Idle.
Wiggle Test
Output Sw Test
Cyl Balance Test
STAR Test Mode
Review Data
Print Data
Tool Setup
On Demand Test Menu
Wiggle Test
KOEO Wiggle Test
KOER Wiggle Test
Select Wiggle Test
KOEO Wiggle Test